Checking and Charging Motorcycle Batteries

By: George Royal
Submitted: 2007-01-17 11:31:02
Print this article | For publisher | Social Bookmarking
Rating:
 

How are Motorcycle Batteries Rated?

The amp/hour (AH) capacity is the basis for rating motorcycle batteries. For example, a 12AH battery can produce one amp of current flow for 12 hours, or two amps for six hours. In order to calculate the amount of time needed to use up a fully charged motorcycle battery by turning the lights on, we have to take power in watts, and divide it by voltage, which gives us the current draw in Amps. Therefore, a 72 watts beam and tail together, divided by 12 volts equals a 6-amp draw. So in 2 hours, the 12AH battery is dead.

Checking Motorcycle Battery:

If you decide to check if your new motorcycle battery is done correctly, follow this actual factory-recommended service procedure.

If the battery is not a maintenance-free type which doesn't have a vent tube, unwrap the battery, unkink the vent tube and snip about a half-inch off the end. Fill it with electrolyte midway (between the high and low level markings on the case) and leave it undisturbed for one or two hours. Remember, the battery will still be at only 65% of full charge at this point. Add electrolyte again if required.

If your battery is a refillable lead-antimony type, it should be charged at one-third of its rated capacity in amp/hours for four to five hours to get it to full charge. Maintenance-free type battery should be charged with a constant-current charger that can drive the charge with as much as 16.9 volts. This should be closely supervised so as not to exceed full charge.

Next, recheck the electrolyte level and add water if required. Let the battery cool so the case contracts enough to fit into its typically tight little holder. Run the new breather tube, if the battery comes along with one, carefully through the original factory routing.

Things to Remember when Charging the Battery:

1. First of all, it is important to remember that Red is positive and Black is negative in order to avoid any accidents such as short-circuits and nasty shocks.

2. The charger should be compatible with the motorcycle battery, and give a greater output than the battery voltage but not too high.

3. Make sure the connections are clean and the electrolyte is at the upper level, and don’t fill the cells up to the very top of the battery.

4. You can either use an optimizer on the battery which can effectively switch off the battery when it’s charged and prevents overheating, or disconnect it manually.

5. It is recommended to put your battery on charge every two or three weeks.

6. An upper and lower level battery should have all the cells on the upper level, not over and never under the lower level.

7. For topping off the low cells, use only distilled water.

8. The minimum charge for a new batter should be at least for 8 hours.

9. If you have a dry battery, fill the cells slowly and leave the battery for around half an hour.

http://batteries-hq.com/ Batteries HQ: everything you need to know about batteries.

Article source: Expert Articles

Most Recent Articles in Motorcycles category

  • A Quick Glance at Harley Davidson History - By: Benicio Brown
    Harley Davidson is one of the most well known motorcycle manufacturers in the world. They were born in America, deriving from Milwaukee, Wisconsin, with the first motorcycle being produced in 1905.
  • Dream Trip Across U.S.: Motorcycle Cover Protected My Ride - By: Jack Labens
    A look at a motorcycle ride across the US and how a motorcycle cover allowed it to happen.
  • A Cool Motorcycle Helmet Will Keep You Safe - By: Frank Medley
    You can protect yourself from serious injury by wearing a cool motorcycle helmet, and look good doing it too. It's an important step toward safety when you're riding your motorcycle.
  • Safe Motorcycle Accessories are Key When Riding - By: Frank Medley
    As a rider, you want to make sure that you have your safety covered at all times. One of the easiest ways to do that is to make sure that you've got the best motorcycle accessories on the market. You want to make sure your safety is protected!
  • In All Types of Weather, Good Motorcycle Jackets are Key - By: Frank Medley
    When you want to stay safe, and to stay comfortable as you ride, it's important that you buy a good motorcycle jacket. A good motorcycle jacket will keep you warm and cool, as well as safe as you're out there on the open road, which will give you peace of mind.
  • Responsible Riders Know Motorcycle Helmet Safety - By: Frank Medley
    As a rider, one of your primary concerns should be motorcycle helmet safety, as it's the helmet that is there to protect your brain from catastrophic injury due to shock. Your helmet is designed specially to keep you safe in many different situations where you may fall or be thrown and strike your head.
  • Want to be Safe? Get the Best Motorcycle Gear! - By: Frank Medley
    When you want to make sure that you're completely protected as you're riding, it's important to invest in the best motorcycle gear. It's a great way to give yourself peace of mind as you're out their on the road, and to know that if the worst should happen, you are wearing the best.
  • Protect Yourself, Get a Good Motorcycle Jacket - By: Frank Medley
    There are many reasons to get a good motorcycle jacket, but the most important one is your safety. If you're a frequent rider, then you've seen the level of injury that can be caused to someone who's not wearing their jacket, even in a minor accident. After your helmet, your motorcycle jacket is the most important piece of safety equipment that you own.
  • Protect Yourself with Motorcycle Safety Ratings - By: Frank Medley
    Motorcycle safety standards are a great way for you to know that you're protected as you're riding. When you're buying gear, always make sure that it's safety rated. It can mean the difference between life and death in an accident, so it's very important.
  • A Motorcycle Gear Check Will Keep You Safe - By: Frank Medley
    A motorcycle gear check is a great way to enjoy your biking lifestyle while it's too cold to ride, and to make sure that you stay safe while you're on the road in the spring. It's a wonderful time to make sure that all your gear is in good shape, and to make sure that you replace what isn't before spring.